Side-by-side, and honest about where each fits.
Two comparisons for AI inspection and metrology on PCB micro-holes, post-dicing edges, and test-pin arrays. Each reflects general differences of typical configurations, not any specific vendor — actual capability is subject to on-site validation.
Insightek vs Rule-based AOI
Where threshold rules over-kill on complex backgrounds and cannot separate saw marks from defects — and where AI verdicts, micron metrology, and a data loop coexist with AOI.
Read comparison →Insightek vs Manual / Microscope Inspection
Where sampling and subjective judgment let defects escape — and where 100% inspection with quantified, verifiable data takes over.
Read comparison →On pricing Pricing depends on your line, configuration, and the phase you start from — software, integrated unit, or standard equipment — so it is scoped after a technical review rather than published as a list price.
Bring the inspection problem you are tired of arguing about.
A technical review of your samples and line. We will tell you which comparison applies to your line — and which does not.